Offset Racing Stripes V1
Let's go racing boys and girls! This was a request of a customer that needed some Badlands Orange stripes. After it was all said and done, we love the look on our own Bronco.
Please watch our video to walk you through this install.
NOTE: 2 sets are sold at a reduced price. Keep it as a backup or in case your first install proves to be difficult.
Colors
Matte black is one of the easiest colors to install in general. It stretches and responds to heat very well.
The gloss black we chose has air egress channels and that is why it is a little more expensive than standard colors. Air egress channels assist in providing a path for air to escape during installation (less bubbles). Some cost is also due to the fact that it is cast versus calendared.
All options have high outdoor durability ratings.
Installation
Clean the application area to prepare it for installation. Just use a wax free detailing spray if your vehicle is not too dirty.
NOTES: We recommend that the installation area be free of wax and not under direct sunlight.
Recommended items:
- Microfiber
- Detailing Spray
- StickerFab Installation Fluid (or Soapy Water)
- Heat Gun or Hair Dryer (optional but recommended)
- Measuring Calipers (or half inch painter's tape)
- 1 1/2" Painter's Tape
- Supplied Felt Tip Squeegee
Wet installs require StickerFab Installation Fluid or one drop of dish or hand soap in a cup of water. Apply to the vinyl so that the first attempt doesn't make the vinyl permanently stick to the surface. Then you can slide it around and push out the extra water once it is in place with your squeegee.
Try doing the install in the shade so it doesn't heat up the vinyl rapidly.
Watch our video for more details. We purposely did a long installation and did not skip any parts. You may fast forward and rewind at your own leisure.