Upper Bumper 2024+ Land Cruiser Topographic Overlays
This is a little accent that adds to our topographic map theme. It is subtle and finished in matte laminate. Fits all 2024+ Land Cruisers.
Features
- TruProtect - UV Resistant Laminate
- TruPrint - Authentic Roland inks and printers
- Made in the USA
INSTALLATION
Items you may want to have:
- Detail Spray (without wax)
- Microfiber Towel or Paper Towel
- Dish with soapy water (drop of dish soap + 1-2 cups of water)
- StickerFab Application Fluid preferred
- Felt tip squeegee
- Heat gun or hair dryer
Ideal installation temperature (weather) is 75-85 degrees. Do the install in the shade unless it is cooler than 75. Clean the application area to prepare it for installation. Do not use a spray with any type of wax in it.
A wet installation is recommended. Use StickerFab Application Fluid or slightly soapy water on the back of the vinyl. Also wet the top of the bumper. This will allow you to move the vinyl around and find the correct alignment. Once aligned, use your fingers to push out the water/air. You can also use a credit card or squeegee to aide you.
Use light heat as needed around the edges to dry out the moisture and increase adhesion. If the vinyl does not want to lay down immediately on the edges, face the bumper towards the sun and give it 30 minutes to dry out. Then push down the edges again and use light heat again as needed.
Notice of Non-Affiliation and Disclaimer:
StickerFab is not affiliated, associated, authorized, endorsed by, or in any way officially connected with Toyota, or any of its subsidiaries or its affiliates.
The name Prado as well as related names, marks, emblems and images are registered trademarks of their respective owners, including Toyota.